BGP Settings

Under Network > Routing > BGP you can configure the BGP settings of the firewall.

In the BGP editing window you can configure the following elements:

Input field	Description
I/0	A slider button indicates whether routing via BGP is currently enabled (I) or disabled (0). Click on the slider button to change this.
Own Name	The own name is displayed.
Domain	The own domain is displayed.
AS Number	Enter your own AS number here.
Neighbors	Name – Enter the name of the BGP neighbor. Address – Enter the IP address of the BGP neighbor. AS Number – Enter the AS number of the BGP neighbor. Password – Enter the password / shared key for authentication with the BGP neighbor. Click on the right to add your entry to the list of BGP neighbors.
Multihop Peers	Set the max. number of hops over which a peer can be reached. Possible values: 0 to 255 (at 0 only directly connected peers are considered).
Redistribute Connected Routes	Specify here whether the networks configured on the firewall should be distributed to all BGP neighbors.
Redistribute Static Routes	Specify here whether the networks configured below should be distributed to all BGP neighbors.
Routes	Specify here the networks to be announced via BGP. Click on the right to add your entry to the list of routes.
Target Routing Table	Routing table into which the learned routing entries are to be written. Possible values: 254 (Main table) or 512 to 65535 (user-defined tables).

If you change any settings, click Save to store your changes or Reset to discard them. Then click Close to quit the editing window.