This table contains further settings for the xDSL.
LANconfig:
Command prompt:
- Interface
- Fixed value for this interface: 1 for XDSL-1, 2 for XDSL-2, etc.
- Vendor-ID
- The code specified by the German Federal Network Agency for LANCOM devices does not work in all countries. In these cases, for example in Switzerland, the alternative identifier must be selected.
- Us Tx limit for QoS
- This switch changes the use of the sync data rate as the QoS data rate. If activated (default), the sync data rate is used as the QoS data rate. Otherwise the sync data rate is not used and the interface behaves like a DSL interface with regard to the QoS data rate.
- Modem firmware
-
As there is no "best" DSL firmware for every situation, you can switch to another modem firmware available in the LCOS, if necessary.
Note: This column is only available for devices with a LCOS that contains an alternative modem firmware.
