Connection mode

Sets the mode in which the connection is established from the device to this BGP neighbor.

Note: All three modes accept connections initiated by the neighbor.
SNMP ID:
2.93.1.2.10 
Console path:
Setup > Routing-Protocols > BGP > Neighbors
Possible values:
Operating
In this mode the device attempts to connect to the BGP neighbor as soon as, among other things, one of the following conditions is met:
  • The BGP neighbor is completely configured.
  • You execute the action Manual start.
  • You start the device.
  • The BGP instance is enabled under Setup > Routing-Protocols > BGP > BGP-Instance > Operating.
  • You enable this BGP neighbor under Operating.
Note: If the connection cannot be established actively, it will be tried again after 120 seconds.
Passive
In this mode the device does not actively connect to the BGP neighbor; instead, it waits for a connection request from the BGP neighbor.
Delayed
In this mode the device waits for a timeout before it tries to connect to the BGP neighbor. The conditions for establishing a connection are the same as for the "Active" mode. The delay time is set under Setup > Routing-Protocols > BGP > Neighbors > Connection-Delay
Default:
Operating

www.lancom-systems.com

LANCOM Systems GmbH | A Rohde & Schwarz Company | Adenauerstr. 20/B2 | 52146 Wuerselen | Germany | E‑Mail info@lancom.de

LANCOM Logo