dot1ad l2tunnel

This command configures an action (tunnel or terminate) for the given reserved MAC address on a particular service.

Note:

All reserved MAC addresses in the range 01:80:C2:00:00:00 to 01:80:C2:00:00:3F are configured with the "terminate" action by default. When a reserved MAC is configured with the "terminate" action, it is not visible under any "show" or show running-config commands.

Default	terminate
Format	`dot1ad l2tunnel vlan vlan id mac-address reserved-mac protocol-id proto-id {tunnel \| terminate \| discard [shutdown]}`
Mode	Global Config

Parameter	Description
protocol-id	The protocol ID field that has to be matched in the ingress packet to perform protocol tunneling. Protocol-id range is from 0x0001 to 0xffff.
reserved-mac	The destination mac-address field in the ingress packet that has to be matched for which the protocol tunneling needs to be configured. MAC address range is from 01:80:c2:00:00:00 to 01:80:c2:00:00:3F.
tunnel \| terminate \| discard [shutdown]	The action to be taken on any packets that match the MAC-address/protocol-id combination. tunnel – The packet is double-tagged with the service definition S-VID) and customer VLAN ID (C-VID) and the packet is forwarded to the NNI port based on the S-VID. This action is taken whether or not the protocol has been enabled on the interface. terminate – If the protocol has been enabled on the interface, then the control PDU is handed to the protocol processing application. If the protocol has not been enabled, then the control packet is dropped. discard [shutdown] – The packet is discarded, regardless of whether the protocol is enabled on the interface. Use the optional `shutdown` keyword to shut down the interface and generate an SNMP trap.
vlan id	The service VLAN ID.