Use this command to enable IGMP Snooping Querier on the system, using Global Config mode, or on a VLAN. Using this command, you can specify the IP Address that the Snooping Querier switch should use as the source address while generating periodic queries.
If a VLAN has IGMP Snooping Querier enabled and IGMP Snooping is operationally disabled on it, IGMP Snooping Querier functionality is disabled on that VLAN. IGMP Snooping functionality is re-enabled if IGMP Snooping is operational on the VLAN.
Note:
The Querier IP Address assigned for a VLAN takes preference over global configuration.
The IGMP Snooping Querier application supports sending periodic general queries on the VLAN to solicit membership reports.
| Default | Disabled |
| Format | set igmp querier [vlan-id] [address ipv4-address] |
| Mode |
|
