Use this command to configure the rate limit and burst interval values for an interface or range of interfaces. Configuring none for the limit means the interface is not rate limited for Dynamic ARP Inspections. The maximum pps value shown in the range for the rate option might be more than the hardware allowable limit. Therefore you need to understand the switch performance and configure the maximum rate pps accordingly.
Note:
The user interface will accept a rate limit for a trusted interface, but the limit will not be enforced unless the interface is configured to be untrusted.
| Default | 15 pps for rate and 1 second for burst-interval |
| Format | ip arp inspection limit {rate pps [burst interval seconds] | none} |
| Mode | Interface Config |
