This command displays the self IP used as source IP by the dual control plane detection protocol (DCPDP), the peer MLAG (VPC) switch’s IP address used by theDCPDP and the port used for the DCPDP. This command also displays if peer detection is enabled. If enabled, the detection status is displayed. The DCPDP message transmission interval and reception timeout are also displayed.
| Format | show vpc peer-keepalive |
| Mode | User EXEC |
Example: The following shows an example of the command.
(Switching) # show vpc peer-keepalive Peer IP address................................ 10.130.14.55 Source IP address.............................. 10.130.14.54 UDP port....................................... 50000 Peer detection................................. Enabled Peer is detected............................... True Configured Tx interval......................... 500 milliseconds Configured Rx timeout.......................... 2000 milliseconds Operational Tx interval........................ 500 milliseconds Operational Rx timeout......................... 2000 milliseconds OAM Session Index.............................. 1 Interface...................................... MEP ID......................................... 0 RMEP ID........................................ 0 type........................................... Y1731 status......................................... Disabled OAM Session Index.............................. 2 Interface...................................... MEP ID......................................... 0 RMEP ID........................................ 0 type........................................... Y1731 status......................................... Disabled
