Use this command to display information about all the configured NTP servers.
| Default | None |
| Format | show ntp servers |
| Mode | User EXEC |
The following table describes the significant fields displayed in the output.
| Parameter | Description |
|---|---|
| Address | Server IP address. |
| Version | Protocol version. |
| Key Id | Authentication key. |
| Minimum Poll Interval | Minimum polling interval in seconds as a power of 2. |
| Maximum Poll Interval | Maximum polling interval in seconds as a power of 2. |
| Prefer | The preference status for this server in the selection algorithm. |
| Burst | If true, a series of packets are sent instead of a single packet. |
| Iburst | If true, a series of packets are sent instead of a single packet during initial synchronization. |
Example: The following shows an example display output for the command:
(Routing) #show ntp servers Address .......................... 1.1.1.1 Version .......................... 4 Key Id ........................... NA Minimum Poll Interval ............ 16 Maximum Poll Interval ............ 16 Prefer ........................... No Burst ............................ No Iburst ........................... No Address .......................... 2.2.2.2 Version .......................... 4 Key Id ........................... NA Minimum Poll Interval ............ 16 Maximum Poll Interval ............ 16 Prefer ........................... No Burst ............................ No Iburst ........................... No
