This command sets the history control parameters of the RMON historyControl MIB group.
Note:
This command is not supported on interface range. Each RMON history control collection entry can be configured on only one interface. If you try to configure on multiple interfaces, DUT displays an error.
| Format | rmon collection history index number [buckets number|interval interval in sec|owner string] |
| Mode | Interface Config |
| Parameter | Description |
|---|---|
| History Control Index | An index that uniquely identifies an entry in the historyControl table. Each such entry defines a set of samples at a particular interval for an interface on the device. The range is 1 to 65535. |
| History Control Data Source | The source interface for which historical data is collected. |
| History Control Buckets Requested | The requested number of discrete time intervals over which data is to be saved. The range is 1 to 65535. The default is 50. |
| History Control Buckets Granted | The number of discrete sampling intervals over which data shall be saved. This object is read-only. The default is 10. |
| History Control Interval | The interval in seconds over which the data is sampled. The range is 1 to 3600. The default is 1800. |
| History Control Owner | The owner string associated with the history control entry. The default is monitorHistoryControl. |
Example: The following shows an example of the command.
(Routing) (Interface 1/0/1)# rmon collection history 1 buckets 10 interval 30 owner myOwner
Example: The following shows an example of the command.
(Routing) (Interface 1/0/1-1/0/10)#rmon collection history 1 buckets 10 interval 30 owner myOwner Error: 'rmon collection history' is not supported on range of interfaces.
