Use this command to show the DHCP Snooping status of all interfaces or a specified interface.
| Format | show ipv6 dhcp snooping interfaces [interface unit/slot/port] |
| Mode | Privileged EXEC |
Example: The following shows example CLI display output for the command.
(switch) #show ipv6 dhcp snooping interfaces
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
----------- ---------- ---------- --------------
1/g1 No 15 1
1/g2 No 15 1
1/g3 No 15 1
(switch) #show ip dhcp snooping interfaces ethernet 1/0/1
Interface Trust State Rate Limit Burst Interval
(pps) (seconds)
----------- ---------- ---------- --------------
1/0/1 Yes 15 1
