Set the operating mode of the access point if it supports Dual PoE. With Dual PoE, both Ethernet ports can be used as PoE input.
- SNMP ID:
- 2.60
- Console path:
- Setup > Power
- Possible values:
- Hitless-Failover
-
Allows uninterrupted operation of the access point in the event that the PoE supply on one of the Ethernet ports fails. The
access point will not restart. This mode requires that the same PoE power is supplied on both Ethernet ports.
Note: For the LX-7500, IEEE 802.3bt (Class 6/51W) is required for full operation.
- Load-Balancing
-
The access point draws power simultaneously via PoE from both Ethernet ports. Typically, the power drawn from both ports is
similar, but this is ultimately influenced by the applied voltage and depends on the switch/PoE injector and/or cabling.
Note: This enables the full operation of the LX-7500 with 2x IEEE 802.3at (Class 4/25.5W).
