Here you configure the channel to be used for WLAN radio operations.
Note: In 5-GHz mode, the channel set here represents a preferred channel. However, since the 5-GHz band requires the use
of Dynamic Frequency Selection (DFS), there is no guarantee that the preferred channel will be used.
Note:
In the 6-GHz band, the following channels can be configured in LCOS LX:
1, 5, 9, 13, 17, 21, 25, 29, 33, 37, 41, 45, 49, 53, 57, 61, 65, 69, 73, 77, 81, 85, 89, 93
These channels are 20 MHz wide. If a channel width greater than 20 MHz is selected (default setting for the 6-GHz band: 160 MHz), the channel set here becomes the primary channel for the wider channel. In this way, the primary channel can also be freely selected within a >20 MHz-wide channel; all you have to do is enter the desired 20 MHz channel.
- SNMP ID:
- 2.20.8.8
- Console path:
- Setup > WLAN > Radio-Settings
- Possible values:
Max. 10 characters from [0-9]
- Special values:
- 0
- The value "0" allows the automatic selection of a suitable channel.Note: With automatic channel selection, the channel is not changed during operation. The channel is only selected when the WLAN module starts.
