OSPF Settings

Under Network > Routing > OSPF you can add a new OSPF configuration or edit or delete an existing OSPF configuration.

In the OSPF edit window, you can configure the following elements:

Input field Description
I/0 A slider switch indicates whether OSPF routing is active (I) or inactive (0). Click the slider switch to change the status.
Router ID Specify the router ID of the OSPF process. The router ID uniquely identifies the router within the OSPF network and is typically specified as an IPv4 address.
Interfaces Specify which interfaces participate in OSPF. For each entry, configure the following:
  • Interface – Select the interface that participates in OSPF.
  • IP Address – Specify the IPv4 address used for OSPF on this interface.
  • Area – Specify the OSPF area assigned to the interface (for example, 0 for the backbone area).
  • Cost – Optionally specify the OSPF cost for this interface. If the field is left empty, the cost is derived automatically from the interface bandwidth.
  • Hello Interval – Interval in seconds for OSPF Hello packets (default: 10).
  • Dead Interval – Interval in seconds after which a neighbor is considered unreachable (default: 40).
Click on the right to add your entry to the interface list.
Redistribute Static Routes Enable this option to redistribute the firewall's static routes via OSPF. When this option is enabled, you can configure a prefix list under Static Routes.
Static Routes Use prefix lists to define which static routes are advertised. For each entry:
  • Seq – Sequence number that determines the rule order.
  • Action – Permit or Deny.
  • Prefix – Network address in CIDR format (for example, 10.0.0.0/8).
  • Min Prefix – Minimum prefix length.
  • Max Prefix – Maximum prefix length.
  • Comment – Optional descriptive text.
Click on the right to add an entry. Prefix lists are processed sequentially (lowest sequence number first), and the first matching rule wins ("first match"). This allows prefixes to overlap intentionally to create exceptions to a more general entry. For example, first deny 10.106.0.0/16 and deny 10.10.0.0/16, then permit 10.0.0.0/8 – this effectively blocks those /16 networks while allowing the remaining ranges within the /8 block. Every prefix list implicitly ends with a deny any/deny all rule, meaning that anything not explicitly permitted is discarded.
Redistribute Connected Routes Enable this option to redistribute directly connected networks via OSPF.
Connected Routes Prefix list for connected routes. The fields are the same as under Static Routes.
Redistribute Kernel Routes Enable this option to redistribute kernel routes via OSPF.
Kernel Routes Prefix list for kernel routes. The fields are the same as under Static Routes.
Filter Incoming Routes Enable this option to filter routes received via OSPF using a prefix list.
Incoming Routes Specify which learned routes are accepted. The fields are the same as for the prefix lists used for redistribution. Click on the right to add an entry.

If you change these settings, click Save to save your changes or Reset to discard them. Otherwise, click Close to close the edit window.

www.rohde-schwarz.com/networks-and-cybersecurity

Rohde & Schwarz Networks and Cybersecurity GmbH | Adenauerstr. 20/B2 | 52146 Wuerselen | Germany | E‑Mail info.rs-nc@rohde-schwarz.com

Rohde & Schwarz Logo