General settings

Navigate to Firewall > General settings to open an editing window where you can adjust some of the central settings for your R&S®LANCOM Unified Firewall.

In the General settings editing window you can modify the following parameters:

Input box Description
Host name Host name of the firewall.
Domain Domain of the firewall. If the firewall is connected to an Active Directory, enter the corresponding Active Directory domain here.
Send usage statistics Collect information about the load and the state of the firewall and send this to Rohde & Schwarz Networks and Cybersecurity GmbH.
Important: No personal information or any of the firewall traffic will be transmitted.
Send crash reports In the event of an error, general information about the system status, the current system configuration and the error that occurred is transferred to Rohde & Schwarz Networks and Cybersecurity GmbH.
Important: The data is used solely for error analysis and is then deleted. No data is disclosed to any third parties.
TFTP Allow or deny access to the firewall via TFTP. TFTP is allowed by default. TFTP access is only enabled in the internal network for sysinfo access.
Atomic Desktop Rule Activation Enable this check box to activate the entire rule set in a single operation. If the check box is disabled, activation is performed in classic mode.
Note: This setting has no effect on activation through the R&S®LANCOM Management Cloud deployment mechanism. Activation through the R&S®LANCOM Management Cloud always takes place in Classic Mode.

If you have made changes, you can use the buttons at the bottom right of the edit window to save them (Save) or discard them (Reset). Otherwise you can close the window (Close).

www.rohde-schwarz.com/networks-and-cybersecurity

Rohde & Schwarz Networks and Cybersecurity GmbH | Adenauerstr. 20/B2 | 52146 Wuerselen | Germany | E‑Mail info.rs-nc@rohde-schwarz.com

Rohde & Schwarz Logo