When using dynamic VPN with IP address transmission over ISDN you must activate this feature. This operating mode is usually then required, when you configure a VPN tunnel with dynamic IP addresses on both sides without dynamic DNS services. All other operation modes of dynamic VPN (for transmitting the IP address by ICMP, to provoke a callback etc.) do not require a registration.
The registration is anonymous, i.e. no personal or firm data is transmitted.
When scanning the device for instance right after the program start LANconfig automatically recognizes if the device must be activated. After confirming the arising hint the LANconfig automatically transmits the required data of the device to the registration server of LANCOM Systems. The release code ist automatically transmitted back to the device and activated. The state of this procedure is visible in LANconfig.
For the registration with WEBconfig the serial number of the device ist required. You can find this information on the bottom side of your device.
When using WEBconfig you can find a link on the first page which leads you to the registrating server of LANCOM Systems. There you must enter the serial number of your device and your e-mail address. After transmitting the data you receive a release code for the device.
To load this release code into your router, please proceed as follows:
Log on with administrator rights on WEBconfig. Select Enable Software Option, which is placed on the entry page. On the following page enter the release code and confirm by clicking on Apply.