If the device operates as a "CFG-mode server", it uses the IKEv2 configuration payload to assign an address from a local address pool to clients. Also, it can assign up to two DNS servers to the client.
To operate this, you use the VPN connection list to enable the CFG mode "Server" on the server and the CFG mode "Client" on the client.
Use this table to configure the IPv6 parameters that the device in the CFG mode "Server" assigns to VPN clients.
- Name
- Contains the name of the interface for the dial-in access.
- Address pool
- First address
- Here you enter the first IPv6 address of the pool of addresses that you want to provide to VPN clients.
- End address
- Here you enter the last IPv6 address of the pool of addresses that you want to provide to VPN clients.
- Name server addresses
- DNS default
- Contains the primary DNS address.
- DNS backup
- Contains the secondary DNS address.