The LANCOM WLAN controllers can form groups of access points based on location information, device properties or network structure. This grouping can also be used as a basis for radio field optimization. Instead of performing a radio field optimization either for all access points or just for one of them, you can address all of the access points within a building tract, with a particular name, or with a particular firmware version.
You can address the groups by using the appropriate group parameters in WEBconfig, LANmonitor and from the command line:
do /Setup/WLAN-Management/start optimization <Group>
The access points can be filtered with the following group-parameter options:
- -g <Group name>
- Access points belonging to the group. Multiple group names can be separated by commas.
- -l <Location>
- Access points with the matching setting for location.
Note: The combination of -l and one of the location options -c to -r is not useful.
- -c <Country>
- Access points with the matching country.
- -i <City>
- Access points with the matching city.
- -s <Street>
- Access points with the matching street.
- -b <Building>
- Access points with the matching building.
- -f <Floor>
- Access points with the matching floor.
- -r <Room>
- Access points with the matching room.
- -d <Device name>
- Access points with the matching device name.
- -a <Antenna>
- Access points with the matching number of antennas.
Note: A combination of the options -d and -a is not useful.
- -v <Firmware>
- Access points with this firmware version only.
- -x <Firmware>
- Access points with a firmware version lower than that specified here.
- -y <Firmware>
- Access points with a firmware version lower than or equal to that specified here.
- -z <Firmware>
- Access points with a firmware version higher than that specified here.
- -t <Firmware>
- Access points with a firmware version higher than or equal to that specified here.
Note: Combinations are possible, e.g. to address access points with a firmware version between two versions.
- -n <Intranet address>
- Access points located on the intranet with the address specified here.
- -p <Profile name>
- Access points included in the WLAN profile specified here.